A single slow drain
- Kitchen sink slow after cooking: grease cooling in the pipe
- Bathroom sink: hair and soap scum in the trap
- Tub: hair, almost always
- Every other drain in the house runs fine
The fix: a cable machine, usually done in under an hour.
Slow sink or a backed-up main line? We find out which before you pay for anything, then clear it properly.
They are two different jobs at two different prices. Pick the one that sounds like your house.
The fix: a cable machine, usually done in under an hour.
The fix: camera inspection first, then hydro jetting the full line.
A cable punches a hole through the blockage but leaves the pipe walls coated, so it closes up again. Hydro jetting scours the full diameter with high-pressure water, which is why a jetted line stays clear far longer.
On any main line we run a camera first. There is no point jetting a pipe with a crushed section or a root mass in a failed joint, and you see the footage before you spend money.
In pre-1980 Edmond homes, caustic drain products eat cast iron from the inside. They can turn a $200 blockage into a $2,000 pipe replacement, and make the line dangerous to work on afterwards.

Mature trees and clay sewer lines are a bad combination, and central Edmond has plenty of both. Roots find the smallest weep at a joint, get in, and grow into a mat that catches everything.
Tell us which drains are slow and we will call back with a time and a fixed price.
Leave your number and we’ll call you back to book a slot. For anything actively leaking, call (405) 555-0142 instead.
A single fixture blockage typically runs $149 to $325. Main line clearing or hydro jetting runs $395 to $850 depending on access and how bad the line is. You get a fixed price before we start.
No, especially in older Edmond homes. Caustic drain products attack cast iron and older pipe from the inside and can turn a straightforward blockage into a pipe replacement. They also make the line dangerous for us to work on afterwards.
Cabling punches a hole through the blockage and gets you flowing again. Jetting scours the full diameter of the pipe with high pressure water, so the line stays clear considerably longer. For main lines with grease or roots, jetting is the better spend.
That is a main line symptom, not a single fixture one. Air is being pushed back through the lowest fixture because the main line is partially blocked. Book it before it becomes a full backup.